Crash di Kerio sotto Windows 2000
Inviato:
ven set 17, 2004 4:23 pm
da Nino
All'avvio dopo l'ultimo aggiornamento di Windows e di Kerio personal firewall ho il seguente errore e il Pc non si avvia.
***STOP 0x00000035(0x813A28E8,0x00000000,0x00000000,0x00000000)
NO_MORE_IRP_STACK_LOCATIONS
Inizio caricamento della memoria fisica.
Scaricamento della memoria fisica su disco (ed un contatore da 1 a 100 veloce) e si riavvia una continuazione.
In modalità provvisoria parte e tutto sembra funzionare.
Aiutatemi x piacere
Grazie mille raga
wrong-subj
Inviato:
ven set 17, 2004 4:40 pm
da Zane
Probabilmente dipende dal Service Pack 2 che il tuo sistema ha installato in automatico.
Devi disinstallare Kerio, andare sul sito del produttore e scaricare una versione più aggiornata.
Quale firewall installo
Inviato:
dom set 19, 2004 2:16 pm
da Nino
Innanzitutto perdonatemi per l'oggetto ma quando mi si è bloccato tutto non avevo idea di che cosa avesse provato il crash ed ho inserito quell'oggetto.
Ora ho biosogno di aiuto perché ho reinstallato tutto e mi manca il firewall solo quale installo visto che scaricando la versione kerio-pf-4.1.0-en-win.exe ho avuto lo stesso problema come posso ovviare.
Aiutameni raga
Grazie mille a tutti.
Inviato:
dom set 19, 2004 2:48 pm
da crazy.cat
Error Message:
STOP: 0x00000035 (parameter, parameter, parameter, parameter) NO_MORE_IRP_STACK_LOCATIONS
Questa è la "semplice" spiegazione che fornisce la microsoft per quell'errore. Ti direi di passare a usare Sygate che fai prima che cercare di capire quale siano i driver che vanno in contrasto con kerio e creano l'errore. Di più non sò.
Explanation:
This is a Windows 2000 Executive character-mode STOP message. It indicates that the I/O system detected a call from one driver to another with no available IRP (I/O request packet) stack locations remaining in the packet for the invoked driver to use. Other memory problems might accompany this error.
User Action:
If this is the first time you have booted after installing new hardware, remove the hardware and boot again. Check the Microsoft Hardware Compatibility List to verify that the hardware and its drivers are compatible with Windows 2000. For information about the hardware, contact the supplier. If you are installing Windows 2000 for the first time, check the Windows 2000 system requirements, including the amount of RAM and disk space required to load the operating system. Also, check the Hardware Compatibility List to verify that the system can run Windows 2000. If Windows 2000 is loaded and no new hardware has been installed, reboot with recovery options set to create a dump file. If the message continues to appear, select the Last Known Good option when you reboot. If there is no Last Known Good configuration, try using the Emergency Repair Disk. If you do not have an Emergency Repair Disk, contact your technical support group.