Collegamento WIFI

[angelos]

Ciao ragazzi, vi scrivo per illustrarvi questa mia questione:
ho 2 computer che devo collegare su 2 appartamenti diversi. Senza portarla alla lunga vi spiego praticamente cosa devo fare!
Ho nell'appartamento A, il computer A e il router A, che devo condividere con il computer B in un appartamento a 100 metri di distanza! Cosicchè, ho preso un ap netgear wg602 v4 che supporta la modalità bridge e ripetitore!
Avendo il mac address del router A devo inserirlo nell' AP del pc 2... in modo che possa ricevere il segnale dal modem-router A e ripetermelo in lan sul pc 2.. Ho configurato tutto, ma nella schermata ho queste opzioni:

Access Point - Operate as a standard 802.11g or 802.11b Access Point. In this mode, the WG602 will communicate with wireless clients only.

Wireless Point-to-Point Bridging - In this mode, the WG602 will communicate with a single bridge-mode wireless access point. And, if you check the Enable Wireless Client Association checkbox, wireless clients will also be serviced by this access point. You must enter the MAC address (physical address) of the other Bridge-mode Wireless Station in the field provided. WEP can (and shou ld) be used to protect this communication.

Wireless Multi-Point Bridging - In this mode, the WG602 will communicate with up to four bridge-mode wireless access points. And, if you check the Enable Wireless Client Association checkbox, wireless clients will also be serviced by this access point. You must enter the MAC address (physical address) of each other Bridge-mode Wireless Station in the field provided. Each wireless ac cess point you enter will be listed in the Wireless Remote Access Point List. When you enter the remote wireless access point MAC address, the WG602 will attempt to validate that the SSID, channel, and WEP configuration of the remote access point matches the settings of this WG602. WEP can (and should) be used to protect this traffic.

Repeater - In this mode, the WG602 will operate as a Repeater only, and send all traffic to the remote AP. If selected, you must enter the MAC address (physical address) of the remote AP.

Client Mode - In this mode, the WG602 will operate as a client bridge only, and send all traffic to the remote AP or peer device. If selected, you must reconfigure the device after reboot.
If using MAC Clone, enter the MAC Address here. The device does a MAC address translation to support multiple Ethernet devices simultaneously. It replaces the source link addresses of all frames transmitted from the wireless interface, and restores the destination link addresses of all frames received by the wireless interface to their real ones.

Quale mi consigliate per poter ripetere il segnale da A nel pc B ?? So l'inglese però non capisco le modalità, non mi so chiare!
Grazie!