Pagina 1 di 1

A.A.A. PROBLEMI con modem interno PCI

MessaggioInviato: gio ott 09, 2003 8:41 pm
da napoleone46
[:o)] <font face="Comic Sans MS"></font id="Comic Sans MS">ho installato da poco Red Hat Linux 7.3 e quest'ultimo non mi rileva il modem Conexant pci interno. Kppp mi dice che il modem è occupato ma sulla lista di periferiche non risulta nessun modem! ho scaricato gli appositi driver dal sito della casa costruttrice e ho installato con successo il pacchetto RPM ma la situazione non è cambiata!! come posso fare? confido nella vostra esperienza!!
<b></b>

A.A.A. PROBLEMI con modem interno PCI

MessaggioInviato: gio ott 09, 2003 8:41 pm
da napoleone46
[:o)] <font face="Comic Sans MS"></font id="Comic Sans MS">ho installato da poco Red Hat Linux 7.3 e quest'ultimo non mi rileva il modem Conexant pci interno. Kppp mi dice che il modem è occupato ma sulla lista di periferiche non risulta nessun modem! ho scaricato gli appositi driver dal sito della casa costruttrice e ho installato con successo il pacchetto RPM ma la situazione non è cambiata!! come posso fare? confido nella vostra esperienza!!
<b></b>

MessaggioInviato: ven ott 10, 2003 12:25 pm
da Erik
Nel sito della casa produttrice del tuo modem scrive:

BEFORE INSTALLING

Remove any old HSF modem drivers, either manually or by running "rpm -e hsfmodem" or "make uninstall" if using the RPM or tar versions of this package respectively.
Note: if you had an older version of this package, it might have been installed under the previous "hsflinmodem" name. In that case, run "rpm -e hsflinmodem" (or "make uninstall" in the *old* package tree).


METHOD A: BINARY RPM PACKAGE (*.{arch}.rpm)

If you have obtained the driver package in RPM format:
1. install the rpm with "rpm -i hsfmodem-{version}.{arch}.rpm"

2. if necessary, run "hsfconfig" to complete the installation, enter license information, or to change your modem's configuration.

If you need to rebuild the binary RPM from source, you can get the TAR package and run: "rpmbuild -tb hsfmodem-{version}.tar.gz" (if rpmbuild is not found, you might have to install the rpm-build package or if you have an older RPM version, try "rpm --rebuild ...")

AFTER INSTALLATION

If an error occurred during installation, please see the sections 'BUGS' and 'REPORTING PROBLEMS' below.
Once the modem is installed and configured, you may access it as /dev/ttySHSF0. Additionally, you can use it via the symbolic link /dev/modem (equivalent to ttySHSF0). If you have more than one HSF modem, the second will be available as /dev/ttySHSF1, the third as /dev/ttySHSF2 and so forth.

Please review the permissions on the device nodes with "ls -l" to ensure that they are adequate for your system.

The "hsfconfig" command can be used to change certain modem configuration options or recompile (generic packages only) the kernel modules after installation. Run "hsfconfig --help" for usage information.


sei sicuro di aver eseguito il tutto ? (ti ha dato qualche errore?)